Super Nintendo Snes

Home > Uncategorized > Super Nintendo Snes

March 12th, 2009 admin Leave a comment Go to comments

Super Nintendo Snes

Remember that these games have been sitting around gathering dirt for more 20. After their introduction into the system fasteners metal game should deal with metal connectors in the system. If there is no dirt between them there is no connection. You must remove all the dirt out of the game, then it will work as it was in 1985.

Dip Q-Tip in alcohol and wipe wet, dirty metal contacts on the cartridge. Then, using the dry end of Q-Tip and RUB disk until you remove all impurities. Removed you can do a lot of time and take a few Q-tips for all the dirt. Want to repeat this step until Q-Tip clean after cleaning. Now that the game is pure, we can quickly remove them from the system with a clean game. Just look game and put it in your system and remove his. Now, fair play and repeat. Each times when you are setting up in the mud system and transfer it to the game, which is to be cleaned. Then there should be no problems. Shopuld system and games will work well.

This cleaning trick works for the Game Nintendo NES, and Super Nintendo SNES, Nintendo 64 N64, Sega Genesis games and most other cartridge based games. Going href = "http://www.DKOldies.com"> HREF = "http://www.DKOldies.com" target = "_blank"> www.DKOldies.com more tricks for cleaning and gaming systems. We also sell a wide range of classical games from Free Shipping.

Remove screws in the bottom of the system.

Enable and start with a plastic top.

Remove screws holding the RF metal shield and remove the cover.

Remove the screws holding contribution of black plastic holder. Please attention as the small plastic card, front of the plate holder slide Home page. Move the handle forward, and delete (it's all right, if the disk has several rotations).

From the rear Motherboard board and remove a set of contacts in the black plastic case. (They will be stable to some, but they just swing and fro, to move off it.)

Dip a toothbrush (preferably not yours; likes to use their own) in cleaning solution and scrub contact Off.

Contact rinse with water and allow to dry.

Lift the back of the board and move contacts in place.

Lift front panel and slide the grip tape on the contacts. Make sure that the card is removed from the front handle the motherboard.

Recapture tape on the screws. (Long his second series of holes on the rear panel).

Connecting and test the system from the net tape. (This is perfectly safe to do is on top).

If the game is does not work, contact, the system can be bent out of shape.

If the system working properly, Set cover (you can leave the RF shield if you want I can not say FCC) and restore the screw on the lower side.

Love play old games, but are tired of flashing. Ever whether strikes in the game, thinking that would help, if you are constantly touching the side console? Take advantage of our leadership to keep game clean and free from dust and dirt, and played to perfection.

About the Author:

Buy Classic Video Games at www.DKOldies.com for the lowest prices anywhere. Original Nintendo Entertainment Systems for as low as 29.99. All our games are in stock and ready to ship. We carry all games, systems and accessories for NES, SNES, N64, Sega Genesis and PS1. Free Shipping Available.

Article Source: ArticlesBase.com – How to Clean Your Nintendo Nes and Other Old Video Games and Systems

Classic Game Room – ARKANOID: DOH IT AGAIN for SNES